输送带的外包装搬运在搬运、存储过程中起着保护作用，搬运搬运时要小心，不可野蛮搬运，以免损坏输送带。吊带更好是用吊车，吊带起吊时，先用一根强度足够的轴杆穿过带卷，然后用带横梁的钢索吊带平稳起吊，以避免吊带边缘受拉而损坏。
The outer packaging of conveyor belt plays a protective role in the process of handling and storage. Be careful when handling, and do not rough handling, so as not to damage the conveyor belt. It is better to use a crane to lift the sling. When lifting the sling, first use a shaft rod with enough strength to pass through the center of the belt coil, and then use a steel cable sling with a cross beam to lift it smoothly, so as to avoid damage caused by tension on the edge of the sling.
输送带卸车应自由、慢、落地，不能一边倾斜地面，搬运带的时候不得随意打开包装。尽量不要卷皮带，如果必须卷，在卷前清理地面，防止皮带被硬物划伤或碰撞。皮带卷取的方向要与皮带卷取的方向一致，严禁反向卷取。也可使用叉车提升和移动，在移动时不会伤害到带体。
The unloading of the conveyor belt should be free, slow and landing. It is not allowed to tilt the ground on one side. It is not allowed to open the package at will when carrying the belt. Try not to roll the belt. If it must be rolled, clean the ground before rolling to prevent the belt from being scratched or collided by hard objects. The direction of belt coiling shall be consistent with that of belt coiling, and reverse coiling is strictly prohibited. The forklift can also be used to lift and move, and the belt body will not be injured when moving.
搬运和存放输送带的注意事项，输送带的外包装搬运在搬运、存储过程中起着保护作用，搬运搬运时要小心，不可野蛮搬运，以免损坏输送带。
Precautions for handling and storage of conveyor belt. The outer packaging of conveyor belt plays a protective role in the process of handling and storage. Care should be taken during handling, not rough handling, so as not to damage the conveyor belt.
第二条输送带储藏大型工程中，输送带和备用输送带，可以也可以存放数月甚至数年，因此储藏条件直接影响输送带的使用性能，良好的储藏条件，可避免各种不利因素的影响。
In the second large-scale conveyor belt storage project, the conveyor belt and standby conveyor belt can be stored for months or even years, so the storage conditions directly affect the performance of the conveyor belt. Good storage conditions can avoid the influence of various adverse factors.
输送带的存放注意事项：b、输送带应存放在干燥、阴暗的地方，理想的存放温度为10~20度，避免存放在5度以上、35度以下的地方。存放于户外时，必须用防水布或类似的覆盖材料覆盖。并且地面垫高，避免影响输送带(特别是棉织物的芯带)。
Precautions for the storage of conveyor belt: B. the conveyor belt should be stored in a dry and dark place, the ideal storage temperature is 10 ~ 20 degrees, and the place above 5 degrees and below 35 degrees should be avoided. When stored outdoors, it must be covered with waterproof cloth or similar covering material. And the ground is padded high to avoid affecting the conveyor belt (especially the core belt of cotton fabric).
传送带不能被太阳直接照射，贮存时应避免紫外线、X射线的照射，贮存地点不得进行电焊作业和进行各种放射性活动。能储存或使用油，汽油，油漆，酸和化学品的地方。不能接触或接近有臭氧和各种强氧化物质。储存的时候好用垫板垫好，塞好塞，以防意外滚动。请勿垂直放置，以免造成扭曲。如存放时间过长，应定期翻转，以防止内压持续作用于同一部位。
The conveyor belt shall not be directly irradiated by the sun. Ultraviolet and X-ray irradiation shall be avoided during storage. Electric welding and various radioactive activities shall not be carried out at the storage site. A place where oil, gasoline, paint, acids and chemicals can be stored or used. Do not contact or close to ozone and various strong oxidizing substances. When storing, it is easy to use the backing plate to pad and plug, so as to prevent accidental rolling. Do not place vertically to avoid distortion. If the storage time is too long, it should be turned over regularly to prevent the internal pressure acting on the same part continuously.
