传动滚筒的直径之间的关系的传送带和布层输送带、传动滚筒的匹配和重新定位鼓以及要求支持辊的槽角应合理选择输送机的按照设计规定。
The matching and re-positioning drum of transmission belt and layer conveyor belt, the matching and re-positioning drum of transmission drum and the groove angle of supporting roll should be reasonably selected according to the design regulations.
进给方向应与输送带运行方向一致。为了减小物料下落对输送带的影响,应采用溜槽来减小物料下落的距离。花纹输送带的接收部分应缩短托辊之间的间距,采用缓冲托辊作为物料泄漏。输送带应采用柔软适中的固定板,避免物料板过硬,刮擦输送带的带面。输送带运行速度不应大于5.0m/s,在运输块状大、磨损大的物料时,应尽量采用低速应使用,并采用固定式犁式卸料装置。当超过规定速度时,会影响输送带的使用寿命。输送带在运输和储存过程中应保持清洁,避免阳光直接照射或雨雪浸泡,避免接触酸、碱、油、有机溶剂等物质,并远离加热装置一米。
The feeding direction should be consistent with the running direction of the conveyor belt. In order to reduce the influence of material falling on conveyor belt, chute should be used to reduce the distance of material falling. The receiving part of the pattern conveyor belt should shorten the distance between the idlers and use the buffer idler as material leakage. Conveyor Belt should adopt soft and moderate fixed plate to avoid material plate being too hard and scraping conveyor belt surface. Conveyor Belt should not run faster than 5.0m/s. When transporting massive and worn materials, low speed should be used as far as possible, and fixed plough unloading device should be adopted. When the speed exceeds the prescribed speed, the service life of the conveyor belt will be affected. Conveyor belts should be kept clean during transportation and storage. Avoid direct sunlight or rain and snow immersion. Avoid contact with acids, alkali, oil, organic solvents and other substances, and keep away from the heating device for one meter.
调整清洗装置和刮板,避免磨损输送带,避免油类或油脂等杂物粘在输送带和托辊或托辊上。主要有一般人字纹、凸人字纹、水平格纹、圆钉纹等类型。本产品适用于大倾角输送块状、粒状、袋装、粉状等物料,如煤、焦、木、砂、水泥袋、食品等物料。
Adjust cleaning device and scraper to avoid abrasion of conveyor belt, and avoid oil or grease and other debris sticking to conveyor belt and idler or idler. There are general herringbone, convex herringbone, horizontal lattice, round nail and other types. This product is suitable for conveying bulk, granular, bagged and powdery materials, such as coal, coke, wood, sand, cement bags, food and other materials.